Acceleration Due to Gravity
G. Khelashvili and C.U. Segre
January 29, 2003
1 Introduction
It is well known that if the effects of air resistance are ignored, any object dropped in the vicinity of Earth’s surface will move
with constant acceleration g. The direction of g is down, towards Earth’s center and it’s magnitude is approximately 9 8 m s
2
.
The motion of freely falling objects is one dimensional motion with constant acceleration. In general, an object moving with
an initial velocity v
0
and a constant acceleration a, obeys the following kinematic equation [1]:
∆s v
0
t
1
2
at
2
(1)
where ∆s is the displacement of the object in time t. For an object initially at rest falling in a gravitational field, equation (1)
reduces to:
h
1
2
gt
2
(2)
where h is the vertical displacement or height. Our experiment is based on equation (2). Namely, if we have means of
measuring height and time of the free fall for any object, then the acceleration due to gravity can be easily determined using
equation (2).
2 Experimental Methods
Our equipment consists of small metal ball, which is our free falling object. This ball is held in a clamp which is released
by a thumscrew. Initially the ball is held in the clamp and completes an electrical circuit which is connected to an electronic
timer. When the thumbscrew is released, the clamp springs open, releasing the ball and opening the circuit, causing the timer
to start. A metal pad is placed directly under the ball and when the ball strikes this pad, the timer stops and the elapsed time
is read. The clamp which initially holds the ball can be adjusted to varying heights above the metal pad on the floor. For this
experiment we positioned the clamp at 7 different heights and released the ball 5 times for each height, recording the elapsed
times. The height of free fall was measured with a meter stick from the bottom of the clamped ball to the metal pad with an
accuracy of 0.5mm.
During the course of the experiment, we noticed several problems with the equipment that could result in systematic errors.
First of all, the release contact was not very reliable, causing the timer to begin slightly before ball entered free fall. This
would result in longer elapsed times and therefore, smaller values for g. Secondly, the contact plate on the detection pad was
not parallel to the floor. The consequence of this is a random deviation of the elapsed time, depending on how high above
the floor the ball made contact with the plate. We were able to minimize the effect of the timer starting early by placing a
stiffer spring in the clamp and throwing out elapsed times which deviated by more than 0.2s from the average. This does not
completely eliminate the problem but does throw out the trials which clearly had problems during release. The second effect
was minimized by carefully sighting vertically from the clamp to the plate and making sure that the location of the plate was
consistent from trial to trial. A consistent release was obtained by holding the clamp steady with both hands whicle releasing
the thumbscrew. This minimized the horizontal velocity of the ball and resulted in a more consistent position of the ball on
the metal pad.
1